Klippan KISS Series Bedienungsanleitung Seite 22

FITTING USING THE THREE POINT BELT
19. Fold down the supporting leg before placing the base in the car. If you fit the KISS 2 Plus seat on the front
seat of the car, the backrest of the car seat must be in upright position.
20. Place the base in the required location in the car. When fitting the seat in the rear. the seat in front of
it may need to be moved forwards slightly.
21. Make sure that the blue arrows in the bottom of the base are located directly in front of one another as
shown in (A). Adjust the arrows if so required; lift up the red lever in bottom of the base as shown in (B) in order
to adjust the position forwards or backwards as shown in (C).
22. Click the car´s seat belt into its lock. Pull the lap belt behind the frame.
23. Thread the lap belt through the blue mounts on both sides.
24. Open the blue belt clip (A) and thread the car seatbelt diagonal part through the blue mount (B) and through
the clip (A) and through the mount (C).
25. Push down the base and tighten the seat belt properly. Make sure that the belt keeps the base on place. Lock
the blue clip and make sure that it is properly locked.
26. Adjust the height of the supporting leg by pulling out the red button. Make sure that it sits firmly on the floor.
The supporting leg must be adjusted so that the base rests on the seat. Move on to fitting of the seat itself.
FITTING THE SEAT
27. Raise the head protector to its upper position.
28. Pull up the handles on both sides.
29. Put the handles together by bending them down towards the centre and clicking them into one another.
30. Position the seat as shown in the illustration. Then turn back 90˚.
31. Put seat on top of the base. Thread red triangle marked "G" towards track of base.
32. Please note indicator (A) is currently red. Now, push down seat into base...
33. ... Put seat in position "1". Listen for an audible "click". Indicator should now show green (A).
34. NOTE! CHECK THOROUGHLY THAT SEAT HAS LOCKED INTO BASE IT SHOULD NOT BE POSSIBLE TO LIFT THE
SEAT FROM THE BASE.
35. Push the head protector down against the seat. Adjust the seat angle using the handle on the front of the
seat (see illustration 1).
36. The tilt position is adjusted easily using the handle of the front of the seat, see illustration 1. Tilt position 1 is
for new-borns. Position 2 and 3 are for children over 9kg.
37. Always make sure that the safety indicator is fully green (A). Never use the seat if you are unsure about how
it is fitted, in this case, contact your nearest dealer.
38. Make sure that the child is securely fastened in the seat. The internal straps must be tightened properly
about the child. Getting a few adult fingers between the straps and the child is good and safe.
Remember: An incorrectly fitted seat could endanger the life of your child in the event of a collision.
COMFORT
39. When the baby protector is lifted out of its base and placed on the ground, it can be used as a soothing
rocker. The rocking function can be prevented as shown in the illustration. Remember to unlock the rocker lock
before returning the seat to the base.
40. Push-handle and wheels are standard. These equipment will allow you to transport your child for short
distances in the seat. Good for mothers who have had Caesarean sections!
41. Sunshade. Protect that little head from the heat and the burning sun. (Accessory)
22