Programming Mode - Elesa DD52R-E-RF Betriebsanleitung

DD52R-E-RF
- LOAd_t : choose
then press
- PrOG_t : choose to program one of the 32 available target positions,
then press
7.7 Battery replacement
The internal lithium CR2477 - 3.0 V battery ensures over 3 years battery life.
The symbol is shown on the display when the battery replacement is required.
The replacement is made by simply removing the front cover without disassembly
of the indicator from the control shaft and keeping unchanged all the configuration
parameters.
To simply remove the battery from the battery compartment, we recommend the
use of a magnet.

8. Programming mode

Press the key
the setting of PASS parameter (see table on page 28), the system may require
you to enter a password.
Press the key
Press the key
automatically dropped after 30 seconds of inactivity.
Models all rights reserved in accordance with the law.
Always mention the source when reproducing our drawings.
one of
to confirm
to start programming
for 3 seconds to enter the programming mode. Depending on
to scroll through the list of parameters.
to exit the programming mode. The programming mode is
Electronic position indicators
Data transmission via radio frequency
the 32 available target positions,
EN
23