Philips GC9040 Bedienungsanleitung Seite 11

1 1 2 2
 Put the mains plug in an earthed wall socket.
 To start the Calc Clean process manually, keep the middle steam
selection button pressed while switching on the appliance at the
same time. Release the steam selection button only when the blue
Auto Calc Clean light flashes.
 Follow steps 1- of the Auto Calc Clean process described above.
Note: The manual Calc Clean process can only be activated if the appliance is
sufficiently cold. If the appliance is too hot for the manual Calc Clean process,
the steam selection button flashes and the appliance continues to heat up for
use.
storage
1 Switch off the appliance (1) and unplug it ().
- Press the cord rewind button to store the cord.
- Empty the Calc Clean tank if it is filled.
 Wind the supply hose round the bottom of the steam generator.
Note: Make sure the supply hose sits properly in the storage groove and inside
the bracket.
 Place the heat-resistant iron resting mat on the steam generator and
put the iron on the mat.
Note: You do not have to wait for the appliance to cool down. You can store the
appliance immediately after use.
EnGlish
11