Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Do not insert the SIM card yet!
Do not yet connect the GSM module with the USB cable of your PC. If
you have already connected it, disconnect it again! First install the USB
driver for the module and the control software with the enclosed CD and
follow the installation instructions.
Now connect the supplied USB cable with the PC and follow the instruc-
tions. Now the device manager detects a new (virtual) COM port.
Connect the antenna on the circuit board next to the TELIT module and
attach this as far away from the module as possible.
Now connect the operating voltage. The green GSM LED (no. 11) starts
to blink after a while. Without inserted SIM card (or wrong pin), the mod-
ule enters the programming mode
Start the software „Control module" at START/PROGRAMS/GSM, set all
desired parameters and transmit the data to the module.
Once the configuration was transmitted, the module performs a restart.
Now you need the SIM card. Disconnect the operating voltage again.
You also need an activated SIM card issued by any provider for com-
missioning. The PIN of the SIM card must be 4-digit and PIN query must
be activated, meaning the PIN query must appear when you insert the
card into a mobile phone.
34
Werbung
Kapitel
Inhaltsverzeichnis
