Conrad Electronic GX106 Bedienungsanleitung Seite 28

To maintain this status and ensure safe operation, the user must comply
with the safety instructions and warnings contained in these operating
instructions.
Read carefully the complete operating manual before start-
ing to use it. It contains important information about correct
operation.
Nor do we assume liability for damage to property or person-
al injury caused by improper use or the failure to observe the
safety instructions! The warranty will be rendered null and
void in such cases.
This module is equipped with highly integrated components. Electronic
components are very sensitive to static electricity discharge. Only touch
the module on the sides and avoid contact with the pins on the circuit
board.
For safety reasons, any unauthorized conversion and/or modification of
the module are not permitted.
When handling products that may come into contact with
electric voltage, you have to observe the valid VDE regula-
tions, especially VDE 0100, VDE 0550/0551, VDE 0700, VDE
0711 and VDE 0860.
Contact an expert if you have any doubt about how the module works or
about how to connect it.
The module may only be put into operation if it was previously installed
in the casing protected from contact. The power must be switched off
when installing the module.
All wiring work must be performed while the power is off.
Direct contact with water must be avoided at all times.
Do not operate the module in rooms or under unfavourable conditions
where combustible gases, vapours or dust are or may be present.
28