Mitsubishi Electric PAR-30MAA Einfache Betriebsanleitung Seite 6

Vane setting
1
Press button 4 ( MENU ).
Room
Cool Set temp.
Mode Temp.
F1 F2 F3
Step 1
Auto
<Note>
The actual vane angle will be different from the vane angle displayed on the LCD when one of the following conditions is met.
• While "Standby" or "Defrost" is displayed
• The room temperature is higher than the preset temperature during the heating mode
• Right after the heating operation (during stand by for switching the operation mode)
Automatic cooling/heating operation
1
Press button 1 ( ON/OFF ).
2
Press button 7 ( F1 ) to display the
operation mode "Auto".
* The current operation mode ("Auto cool" or "Auto heat") will be displayed after the mode is determined.
If "Display/non-display of COOL/HEAT during AUTO mode" has been set to "Non-display" while making the initial
settings, only "Auto" will be displayed. Refer to the Installation Manual for details about initial settings for the
remote controller.
Ventilation operation
<When performing an interlocked operation of the ventilation unit with the indoor unit>
Press button 1 ( ON/OFF ) to turn both the indoor unit and the ventilation unit on.
<When operating the ventilation unit individually>
1
Press button 4 ( MENU ).
Room
Cool Set temp.
Mode Temp.
F1 F2 F3
Indoor unit fan may operate even when the ventilation unit is operated individually, depending on the models of the indoor unit and the
ventilation unit.
6
2 "Vane•Louver•Vent.(Lossnay)" is
selected. Press button 2 ( SELECT ).
Main
Fri
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
Auto
OU silent mode
Main display:
Cursor
Fan
F4 F1
Step 2 Step 3
2 "Vane•Louver•Vent.(Lossnay)" is
selected. Press button 2 ( SELECT ).
Main
Fri
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
Auto
OU silent mode
Main display:
Cursor
Fan
F4 F1
Main menu
Page
F2 F3 F4
Step 4 Step 5
When the room temperature is higher than the preset
temperature, cooling operation starts.
When the room temperature is lower than the preset
temperature, heating operation starts.
F1
Main menu
Page
F2 F3 F4
3 Press button 7 ( F1 ) or 8 ( F2 )
to change the vane angle.
Fri
On
Low
Vane Vent. Louver
F1 F2 F3 F4
* The settable vane
Swing
angle varies with
the model of indoor
units.
3 Press button 9 ( F3 ) to
change the fan speed.
Fri
Low On
Vane Vent. Louver
F1 F2 F3 F4