Wiring Instructions; Ground Connection; Input Connections - AXTON AXB20P Einbauanleitung

WIrING INstruCtIoNs

Important:
Before any wiring, always remove the negative terminal of the battery to pre-
vent short-circuiting. this is also the last lead to be (re-)connected.
Connect this lead only after having completed and checked all other connections. The batte-
ry terminal (+12V) must be connected directly to the positive terminal of the vehicle battery
to provide an adequate voltage source and minimize noise. Connecting the battery terminal
lead to any other point (such as the fuse block ) will reduce the power output and may cause
noise and distortion. Connect it to the terminal of the battery after all other wiring is com-
pleted.

GrouND CoNNeCtIoN

The ground terminal (GND) connection is also critical to the correct operation of the ampli-
fier. use a wire of the same gauge as the power connection and connect it between
the ground terminal (GND ) of the amplifier and a metal part of the vehicle close to the
mounting location. This wire should be as short as possible and any paint or rust at the
grounding point should be scraped away to provide a clean metal surface to which the end
of the ground wire can be screwed or bolted.
remote turN-oN CoNNeCtIoN
The amplifier is turned on by applying +12V to the remote turn-on terminal (REM). The
wire lead to this terminal should be connected to the „Amp remote" lead from the car
stereo which will provide the +12V only when the car stereo is turned on. If the car stereo
does not provide an „Amp remote" lead, the remote turn-on lead may be wired to an
„Accessory"or „Radio" terminal in the car's fuse block. This will turn the amplifier on and off
with the ignition key, regardless of whether the car stereo is on or off. The remote turn-on
lead does not carry large currents. So a thin wire may be used for this application.

INPut CoNNeCtIoNs

This amplifier features both high level and low-level input capability. Use either the low-
level or high-level inputs, not both. If the car stereo does not provide low-level outputs,
the amplifier may be connected via the speaker (high-level) outputs from the car stereo.
Wire the speaker leads from the car stereo to the 5-pin adaptor harness as shown in the
diagram (shielded cables are not required for this application) and plug the connector into
the high input connector on the amplifier.
Gray
Gray/Black
Black
toP VIeW
High Level Input Plug High Input
GND
+ -
-
+
– 7 –
Green
Green/Black