AXTON AXB20P Einbauanleitung Seite 6

mouNtING
Note that the amplifier generates heat, so a well ventilated mounting place
n
is necessary or it will easily overheat.
Keep the wire connections as short as possible, with sufficient length, in order to
n
minimize power losses and provide a higher audio output of the system.
For safety reasons route all power and speaker wiring by using the existing
n
wire channels.
To minimize damage to the cables, take care that they do not pass through sharp
n
edged metal. Use rubber grommets were required.
Lay all cables as far away as possible from the ignition cables, modules in the boot
n
and under the dashboard, as these create interference.
add a main fuse ( 60 a ) to the (+) power cable in a distance of not more than
n
30cm from the positive battery pole (fire hazard!)
Keep the length of the power cable as short as possible.
n
The power cable should have at least a cable cross section of 10mm
n
AWG). Smaller cross sections are reducing the output power, are causing
distortions and may be triggering the overheat protection of the amplifier.
1. Position the mounting brackets.
2. Use the tapping screws to fix them.
– 6 –
(8 Gauge
2