Maintenance; General; Maintenance Schedule; General Inspection - Husqvarna LC 247 Bedienungsanweisung

General

WARNING! The user must only carry out
!
the maintenance and service work
described in this Operator's Manual.
More extensive work must be carried out
by a service workshop.
Switch off the engine before carrying out
any checks or maintenance. Prevent
unintentional starting by removing the
ignition cable from the spark plug.
Prevent accidental starting by removing the ignition cable
and, where appropriate, the start battery/safety switch.
The life span of the machine can be reduced and the risk
of accidents can increase if machine maintenance is not
carried out correctly and if service and/or repairs are not
carried out professionally. If you need further information
please contact your nearest service workshop.
CAUTION! When the machine is tilted, make sure the air
filter always is placed in the highest position.
• Always use genuine accessories.

Maintenance schedule

In the maintenance schedule you can see which parts of
your machine that require maintenance, and with which
intervals it should take place. The intervals are calculated
based on daily use of the machine, and may differ
depending on the rate of usage.
Weekly
Before starting

maintenance

General inspection Spark plug
External cleaning Muffler*
Oil level
Cutting equipment
Cutting cover*
Inspecting and
adjusting the drive
belt
Engine brake
handle*
*See instructions in the section "Machine's safety
equipment".
Please see the engine Operator's Manual for additional
information about servicing the engine.

General inspection

• Check that nuts and screws are tight.
MAINTENANCE
External cleaning
•
•
•
•
When cleaning under the cutting cover, empty the fuel
tank and put the machine on its side with the muffler
down. Empty the fuel tank.
Oil level
IMPORTANT! Allow the machine to cool. Hot oil can
cause severe burn injuries.
The lawn mower should stand on flat ground when you
check the oil level. Check the oil level with the dipstick on
the oil filler cap.
•
•
•
Cutting equipment
Monthly
maintenance
•
Air filter
Fuel system
•
CAUTION! The blades should be balanced after
sharpening. Balancing, replacing or sharpening the
blades should be conducted by a service workshop.
Damaged blades should be replaced when hitting
obstacles that result in a breakdown. Let the service
centre assess whether the blade can be sharpened or
must be replaced.
Dismantling
Prevent accidental starting by removing the ignition cable
and, where appropriate, the start battery/safety switch.
•
Brush leaves, grass and the like off of the lawn mower.
Do not use a high pressure washer to clean the
machine.
Never flush water directly on the engine.
Clean the air intake on the starter. Check the starter
and starter cord.
Remove the oil cap and wipe the dipstick clean.
Put the dipstick back in.
If the oil level is low, fill using engine oil up to the upper
level on the dipstick.
WARNING! Always wear heavy-duty
!
gloves when servicing and maintaining
the cutting equipment. The cutters are
very sharp and cuts can occur very
easily.
Check the cutting attachment for damage or cracks. A
damaged cutting attachment should always be
replaced.
Always ensure the cutter is well ground and balanced
correctly.
WARNING!
!
Lock the blade with a wooden block. Loosen the blade
bolt and remove the blade bolt, the washer and the
–
English 81