Operating Elements And Connections - Monacor SAM-300D Bedienungsanleitung

Amplifier Insertion Module
for Subwoofers
These instructions are intended for non-pro-
fessionals with basic knowledge in DIY speaker
building . Please read the instructions carefully
prior to operation and keep them for later
reference .
SAM-300D
DIGITAL SUBWOOFER MODULE
MONACOR INTERNATIONAL
1
230 V~ / 50 Hz
2
3
1 Operating Elements
and Connections
1 POWER switch
2 Mains jack for connection to a socket
(230 V/ 50 Hz) via the mains cable provided
3 Support for the mains fuse
Always replace a blown fuse by one of the
same type .
4 Status LED
red = standby
green = power amplifier switched on
5 LEVEL control
6 CUT OFF control to set the cut-off frequency
for the subwoofer
8
SAM-300D
ZUM FALSCH 36 28307 BREMEN GERMANY
• • •
T2.5AL
230V~ / 50Hz /440VA
AUTO
ON
OFF
POWER
FUSE
HIGH LEVEL INPUT
L R
7 PHASE control to shift the phase of the out-
put signal compared to the input signal
8 Input LINE IN (RCA jacks) for signals with line
level; when both jacks are connected (e . g .
stereo signal), the signals internally create a
sum signal (mono)
9 Output LINE OUT (RCA jacks) to route the
input signal e . g . to another amplifier
10 Screw terminals HIGH LEVEL INPUT as a sig-
nal input to connect the speaker outputs of
a power amplifier [instead of using the RCA
jacks LINE IN (8)]
STANDBY/
POWER
LEVEL
MIN MAX
CUT OFF
40 Hz 200 Hz
PHASE
0° -180°
L/LFE R
LINE
IN
LINE
OUT
4
5
6
7
8
9
10