SPORTSTECH HTX100 Benutzerhandbuch Seite 37

Step 6:
Turn the jumping blanket upside down. Now make sure that the side of the jumping blanket, which has a hole, is
parallel to the frame tube connection. (See Figure 8)
Step 7:
Hook in the rubber band on the insi-
de of the clamp. Using the clamping
tool, pull it around the pipe and hook
it into the outer part of the clamp.
(See Figure 8)
Figure 9
Step 9:
Put together the remaining rubber bands with the tensio-
ning tool so that the result looks like in Figure 10.
Figure 8
Figure 10
37
Step 8:
Put together all the rubber bands as described in step 7.
Start at the corners and proceed like the order shown in
Figure 9.