Maxi-Cosi Easy Fix Gebrauchsanweisung Seite 8

EXI0195_GBA_EasyFix_BW_I:--
GB
C. Adjusting the length of the support leg
• IMPORTANT! Always use the support leg to ensure the safe use of the Maxi-Cosi EasyFix.
10 • IMPORTANT! Make sure the support leg is fully folded out and locked at the hinge point (10).
11 • Keep the silver control button on the support leg pressed (11,1) and move the support leg downwards
until it reaches the floor of the car (11,2).
12 • IMPORTANT! Make sure the indicator at the base of the support leg is green (12).
• In some cases the Maxi-Cosi EasyFix may not be fully supported by the car seat, but entirely by the support leg.
• Release the control button and "click" the support leg into the locked position.
• Check to make sure the support leg is securely locked and stays in position by trying to move it up or
down without pressing the control button.
Checklist...
To ensure the optimum safety of your child, check the following after installation:
• Both Isofix connectors are securely attached to the Isofix anchor points: the indicator on the central
button on the support leg should be green.
• The support leg is fully folded out.
• The indicator on the base of the support leg is green.
• The entire Maxi-Cosi EasyFix is installed securely and firmly in the car (check by pulling on the Maxi-Cosi
EasyFix).
D. Removing the Maxi-Cosi EasyFix
• Restore the support leg to its start position by pressing the control button (13,1) and sliding the support
13
leg upwards (13,2).
• Disconnect the Isofix connectors by pressing the central button on the support leg (14). The indicator on
14
the central button on the support leg should be red. Considerable force may sometimes be needed in
orrder to release the buckle. If this is the case, try pushing the Maxi-Cosi EasyFix into the back of the
vehicle seat while pressing the release button.
• Remove the Maxi-Cosi EasyFix from the Isofix anchor points (15).
15
• Remove the Maxi-Cosi EasyFix from the car.
12
16-09-2008 14:48
English
Pagina 12