Rapid 100E Bedienungsanleitung Seite 37

gb
C Rating plate with the following data:
D The machine complies with the German requirements for radio
interference suppression. (This mark will be found on machines sold
in certain countries).
E The machine has been tested and approved by TÜV. (This mark will be
found on machines sold in certain countries).
F The machine has been tested and approved by UL and CSA.
(This mark will be found on machines sold in certain countries).
dESCrIptIon of rapId 100E
The Rapid 100E is an electrically powered table stapler. Stapling is
automatic when the object to be stapled is pushed into position under
the visor.
The parts of the machine are shown in figure 2.
G Visor
H Magazine
J Stapling anvil
K Wheel for adjusting
stapling force
The Rapid 100E is suitable for two different types of stapling and by simple
manipulation can be switched from one to the other:
- Normal stapling with the staple legs folded inwards.
- Pinning with the staple legs folded outwards.
Pinning can be used for stapling small bundles of paper which will be
unstapled later, e.g. for copying. Pinning is easy to remove by pulling out the
staple in its longitudinal direction.
The Rapid 100E is available with various types of magazine suitable for
staples with different wire thickness. Staples of different types are
designated 44 and 66. Always use original Rapid staples.
The Rapid 100E is designed for staples with a leg length of 6 and 8 mm. To
ensure proper stapling the leg length should be at least 3 mm longer than
the thickness of the stapling object.
The type of original Rapid staple that should be used is shown on the front of
the magazine.
32
Manufacturer.
Type designation of machine.
Serial number.
Electrical data.
Max. number of staples per minute.
Marking for type approval.
CE mark for compliance according to EU Directive
(This mark will be found on machines sold in certain
countries).
Year of manufacture.
L Switch
M Trigger
N Depth scale