Care And Cleaning - AEG LAVATHERM 65170AV Benutzerinformation

34
tea cloth
APPLIANCE SETTINGS
Water hardness
A
Water hardness can be different
for different locations. If you
know your local water hardness
you can adjust the sensor in
your appliance to get the better
result of the drying.
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time the A and B
buttons and hold down until LEDs
show the settings:
– Einde (End) - low conductivity
<300 μS/cm

CARE AND CLEANING

CLEANING THE FILTER
At the end of each cycle the filter indi-
cator is on to tell you that the filter must
be cleaned.
The filter collects the fluff. The
fluff occurs while the cloths are
dried in the tumble dryer.
1. Open the door.
100 g
B
– Afkoelen (Cooling) - medium
conductivity 300-600 μS/cm
– Afkoelen (Cooling) and Einde
(End) - high conductivity >600 μS/
cm
3. Push the Start/Pauze (Start/Pause)
button again and again until you set
necessary level.
4. To memorise setting push at the
same time the A and B buttons
Zoemer (Buzzer) permanent off
A B
1. Turn the programme dial to one of
programmes.
2. Push at the same time the A and B
buttons and hold down for approxi-
mately 5 seconds.
3. The buzzer is by default always off.
2. Pull the filter.
3. Open the filter.