Klarfit 10023091 Handbuch Seite 6

Please find a video tutorial for the assembly on the included DVD!
General hints
• Pick an appropriate site for the assembly of your pole dance pole. Keep in mind that
you will need enough space around to not get hurt. Make sure that there is enough di-
stance to any walls, steps, stairs, windows and any other obstacles. Try walking around
the imagined point you want to install the
ally sure, the pole should mark the center of a circle with a diameter of at least 3 meters.
• The ceiling and the floor must be stable and resilient. Make sure that there are no cavities in the
roof, that would not stand the pressure
Calculation of the pole height
Floor to roof distance in mm
2235 - 2375
2360 - 2500
2485 - 2620
2610 - 2745
2735 - 2870
2860 - 2995
2985 - 3120
3110 - 3245
3235 - 3310
The pole is (fully assembled without using the extensions) suitable for roof heights of 2235 - 2375mm.
For any higher rooms please use the extension pieces included.
The safety limit is 140mm: This is the maximum addable length the pole can expand using the height
adjuster (without the extension pieces).
Installation
• Fit the extensions to the base (if required).
• Attach lower main pole to the base. Tighten firmly by hand.
• Take the adjuster cover and cove it to the main pole A then slide the upper
dome onto adjuster shaft.
• Switch the flange upside. Attach the upper pole to the lower pole (You might
need a ladder). Screw up tightly and hold vertically.
• If you calculated the height of the room right, the distance between the
dome and the ceiling is less than 140mm.
• Unscrew the adjuster by hand until it is firm to the ceiling. Make sure the
upper dome is flat. Let go of the pole and make sure: a) the pole stands 100%
vertically and b) the pole is under a joist.
• Before fasten the pole make surer the silicone pads that protect floor and cei-
ling are in place on top of the pole as well as below the base plate.
• Tighten pole adjuster with spanner until it is really firm. Check for any possible
movement and retighten in this case. Screw the nut down until it firmly is at-
tached to the main pole. Slide the adjuster cover up. Press in the two sprung
pins and lock in place.
Assembly
pole with your arms stretched. To be re-
What extension is required?
none
125mm
250mm
250mm + 125mm
500mm
500mm + 125mm
500mm + 250mm
500mm + 250mm + 125mm
1000mm
Additional extensions?
no
no
no
no
yes
yes
yes
yes
yes
6