Set The Inverted Configuration - Axis Q8685-E PTZ Sicherheitsinformationen

AXIS Q8685-E PTZ Network Camera
4. Tilt the bottom cover backward to its end position and tighten the two front screws of
the positioning unit (T20, torque 3.0 Nm).
5. Tilt the bottom cover forward to its end position and tighten the two rear screws of
the positioning unit (T20, torque 3.0 Nm).
NO TICE TICE
NO NO TICE
To reach the positioning unit screws, use a screwdriver with a long enough blade (see
picture above).

Set the inverted configuration

Note
This task only applies when using the inverted configuration.
32