Resetting To The Factory Default Settings; Further Information; Warranty - Axis M3113-R Installationsanleitung

AXIS M31 Network Camera Series

Resetting to the Factory Default Settings

This will reset all parameters, including the IP address, to the Factory
Default settings:
1. Disconnect the network cable from the camera.
2. Remove the top cover by loosening the 2 captive screws.
3. Press and hold the Control button and reconnect the power\network
cable.
4. Keep the Control button pressed until the Status indicator displays
amber (this may take up to 15 seconds).
5. Release the Control button. When the Status indicator displays
green (which can take up to 1 minute) the process is complete and
the camera has been reset.
6. Re-assign the IP address.
It is also possible to reset parameters to the original factory default
settings via the web interface. For more information, please see the
online help or the user's manual.

Further Information

The User Manual is available from the Axis Web site at www.axis.com
Visit Axis learning center www.axis.com/academy for useful trainings,
webinars, tutorials and guides.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware
available for your network product. To see the currently installed
firmware version, see Setup > About.

Warranty

For information about Axis' product warranty and thereto related
information, see www.axis.com/warranty
Page 17