Yedoo DRAGSTR Benutzerhandbuch Seite 5

Installation manual
6.a 6.b
20–22 Nm
Insert the stem into the frame tube of The highest possible height of the
the scooter and adjust the handlebar handlebars is marked with vertical
height taking care not to position it grooves, at the maximum height the
above the marked line, see pic. 6.b. grooves should be visible only partly.
Make sure that the handlebars are
straight and then tighten the screw on
the stem.
7.b 7.c
Two-position rear fork enables you to The upper fork position, which reduces
adjust the height of the footrest above the height of the footrest, is designed for
the ground. Use the lower position riding on a smooth, flat surface. Riding
for riding over rough terrain. Close will be less physically demanding. The
the quick release lever. It should point closed quick release lever should point
upwards. downwards.
EN
7.a
2
Max
1
Installing the rear wheel differs from
the front wheel installation.
Release the brake cable from the guide
(1), Put the wheel in one of the two fork
dropouts (see 7.b, 7.c.) then centre the
wheel and tighten the quick release
mechanism (2).
8.
3
1
2
Installing the brake cables
Squeeze the brake lever to the maximum
and insert the end of the brake cable
into the round lug (1). Insert the cable
into the groove and tighten the set
screw (2) and the nut (3). Repeat the
process with the other brake. The rear
brake cable is usually mounted on the
right brake lever and the front brake wire
on the left.
8
9.
Dragstr
5–6 Nm
Adjusting the handlebars
Adjust the angle of the handlebar
according to the needs and height of
the rider and tighten the screws. A larger
angle gives more space for the rider and
provides a more sporty riding style.
10.b 11.
2
For the best results, stand on the For both the front and the rear wheel
footrest, grab the handlebars and stretch the brake adjustment
your fingers so they extend in a straight
line from your hands. Set the brake Insert the brake cable back into the
levers in this position and tighten the guide (1) and check the brake pads
two mounting screws, see 10.a. during braking, ensuring thattheir entire
surface fits tightly against the side of the
rim. If not, adjust the screw (2), which
attaches the brake pads to the shoulders
of the V-brakes. The brake pads must not
touch the tyre.
9
10.a
Rodstr
6–8 Nm
Friday
Adjusting the angle of the brake levers
On both brake levers loosen the screw
on the sleeve.
6–8 Nm
12.
1
2
2
Check that the brake pads move away
is the same. from the rim sufficiently (1–2 mm) when
the brake lever is released. The distance
of the brake pads can be adjusted by
tightening or loosening the brake cable
anchor bolt (1). If the brake pads come
into contact with the rim while the wheel
spins, adjust the spacing of the brake
arms symmetrically with the tensioning
bolts (2).
5–6 Nm
1
2
EN