Yedoo DRAGSTR Benutzerhandbuch Seite 4

Introduction
We recommend that you entrust the installation, adjustment
and regular maintenance to a specialist bicycle shop. Improper
intervention can lead to damage of the scooter or to an accident
with serious health consequences.
If you are technically capable, do not worry; this manual
contains all the information you need to help you assemble your
new scooter.
Send your questions, comments and suggestions for
improvement of our products by e-mail to: info@yedoo.eu.
More information from the
world of scooters and the list
of distributors can be found at
www.yedoo.eu.
EN
Installation manual
1.
The installation is the same for all
three models (Dragstr, Rodstr, Friday),
it differs only in minor details (see
additional pictures). When tightening
the connections do not exceed the
specified tightening torque.
Installing the front wheel
Insert the quick release mechanism into
the wheel ensuring that on both sides of
the wheel the narrow ends of the springs
face the centre of the wheel.
4.
Tighten the adjustment nut of the
quick release mechanism to the correct
position. When it is in the correct
position you will feel a noticeable
resistance just before you close the
mechanism completely. Close the
quick release lever in a position
so it does not touch the fork and
simultaneously it cannot be opened
accidentally while riding.
6 7
2. 3.
First check that the front fork of the Insert the wheel into the front fork so it
scooter is aligned correctly (the V-brake is exactly in the middle. Caution: When
shoulders should be pointing forwards inserting the wheel, ensure that the
towards the front of the scooter), then arrow on the tyre sidewall points in the
release the brake cable from the guide. direction of rotation when the scooter
is rolling forwards.
5.
Dragstr
5–6 Nm
Handlebars installation
Install the handlebar on the stem.
Tighten the screws only slightly so you
can adjust the angle of the handlebars
later on. 6–8 Nm
Direction
of rota-
tion
Rodstr
6–8 Nm
Friday
EN