DJI DATALINK PRO Kurzanleitung Seite 7

•
Full Duplex Mode and Broadcast Mode can be turned on or off in
DJI Assistant 2.
•
Be sure to toggle the 4-position switch to the UART_SW1
position if using the D-RTK and working in Full Duplex Mode or
Broadcast Mode, otherwise the D-RTK may fail to receive data
from the DATALINK PRO.
Linking Procedures
The Base Station and Mobile Station come already linked out of the box.
Note that frequency linking is required if any device is changed or added.
1. Enable the D-RTK Ground System's battery to power on the DATALINK
PRO Base Station.
2. Hold the Base Station's Linking Button for about 3 seconds to enter
Linking mode. The Working Status LED will blink red and green
alternatively.
3. Enable the D-RTK Ground System's battery to power on the DATALINK
PRO Mobile Station.
4. Hold the Mobile Station's Linking Button for about 3 seconds and wait
for linking.
5. The Base Station and Mobile Station will exit Linking mode and connect
with each other if successfully linked.
6. Follow linking procedures 2-5 to link other Mobile Stations one by one
when setting up a single-to-multiple system.
Configuring Parameters with DJI Assistant 2
1. Download DJI Assistant 2 from www.dji.com and install it on your computer.
2. Toggle the 4-position switch to the COMBO_SW4 position, connect the
Base Station to the computer with DJI Assistant 2 running, and then
configure parameters according to the message prompts.
3. Configure the Mobile Station in the same way. If multiple Mobile Stations
are used, you must configure each Mobile Station one by one.
•
Power cycle the DATALINK PRO, Flight Control System and
D-RTK after upgrading.
•
DJI Assistant 2 supports Windows 7 (or later) or Mac OS X 10.9 (or
later).
© 2016 DJI All Rights Reserved.
5