Charging The Battery - Invacare Jasmine Gebrauchsanweisung

Brakes
1. Stand behind the hoist and take a good hold of the handle bar.
2. Press the pedals downwards with the foot on the back castors to activate the brake.
3. Press the pedals upwards with the foot to release the brake.
Never try to activate/deactivate the brakes by hand - risk of squeezing !
Moving the hoist
1. Stand behind the hoist and take a good hold of the handle bar.
2. Release the brakes of the back castors.
3. Now the hoist can be pushed or pulled to the desired location.
Note: To negotiate raised obstacles during movement of the unloaded hoist, it is
recommended to pull the hoist backwards. This operation should only be performed when
the hoist is in the unloaded condition.
Use handle bar on the mast at all times to push or pull the patient hoist.
Turning in place
The hoist can be turned (rotated) in place for transfers with limited floor space.

Charging the battery

The hoists are equipped with an internal charger. It is recommended to charge the batteries
regularly to ensure optimal use of the hoist and prolong the the batteries. Furthermore, it is
recommended to charge the batteries before first use.
The control unit is equipped with a sound signal, which will beep when operating with low
battery capacity. It is recommended to charge the batteries as soon as the sound signal is heard.
In addition, Jasmine
capacity, when pressing any hand control button. When installing the battery onto the control
unit, it takes a few seconds before the hoist is operational.
How to charge the batteries:
1. Connect the mains cable to the control unit and plug it in. It takes about 4 hours to charge
the batteries. Charging must take place in a room with good air ventilation. The charger
stops automatically when the batteries are fully charged.
2. Remember to disconnect the charger cable before using the hoist again.
The emergency stop must not be activated - otherwise it will be impossible to
charge the batteries. While charging takes place the hoist cannot be used.
Do not use or move the hoist without unplugging from the socket outlet.
Do not attempt to use the hoist if the battery housing is damaged. Replace a
damaged battery housing before further use.
Press down to activate
is equipped with a display, indicating the approximate remaining battery
TM
Push to release
13