Safety Warnings; Function - Trix BR 141 Bedienungsanleitung

Function

• Built-in electronic circuit for operation with a conventional
DC power pack (max. ±12 volts), Trix Systems, Trix Selectrix
or NMRA DCC digital systems.
• Automatic system recognition between digital and analog
operation. No automatic system recognition between Selectrix
(SX) and DCC.
• The full range of functions is only available under Trix Systems
and under DCC.
• Headlights for the locomotive change over with the direction
of travel. They can be turned on and off in digital operation.
• This set consists of a locomotive with cars. The locomotive is
equipped with an electrical pickup changeover feature. For
that reason the locomotive cannot be operated without the
cars that belong to it. If you still want to run the locomotive by
itself, then the electrical pickup changeover feature must be
shut off with two jumpers (see page 30).
Notes on digital operation:
• The first time the locomotive is used in a digital system
(Selectrix or DCC), the decoder must be set for this digital
system. To do this, the decoder must be programmed once in
this digital system (Example: changing an address).
• The operating instructions for your central unit will give you
exact procedures for setting the different parameters.
• Correct programming with the 66920 Mobile Station is possible
starting with version number 034.
• Information about DCC Operation:
The setting done at the factory does not permit operation
with opposite polarity DC power in the braking block. If you
8
want this characteristic, you must do without conventional DC
power operation (CV29 / Bit 2 = 0).
Safety Information
• This locomotive is only to be used with the operating system it
is designed for.
• Please make note of the safety information in the instructions
for your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for thispurpose. The interference
suppression set is not suitable for digital operation.
• Only the Trix decoder installed at the factory can be plugged
into the 21-pin connector.
• WARNING! This product contains magnets. Swallowing more
than one magnet may cause death in certain circumstances. If
necessary, see a doctor immediately.
The necessary maintenance that will comes due with normal
operation is described below. Please see your authorized Trix
dealer for repairs or spare parts.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.