Installation; Inserting Batteries; Anemometer - CO/Tech FT0203 Bedienungsanleitung

Installation

Remove
the product from Insert batteries
the packaging and into the sensors
check that nothing (the transmitters)
is missing

Inserting batteries

Note:
Insert the batteries into all sensors before inserting batteries into the indoor unit. When
power is supplied to the indoor unit, an automatic search for nearby sensors will begin.
When inserting the batteries into the units, check the markings in the battery compartment
to ensure the correct polarity.

Anemometer

1. Remove the battery cover on the underside of the anemometer.
2. Insert 4 × AAA/LR03 batteries. The LED indicator will be illuminated for 3 seconds,
followed by continued flashing once every 16 seconds to indicate that data is
being transmitted from the unit.
3. If the LED indicator does not flash after the batteries have been inserted, reset
the sensor by pressing [ RESET ].
4. Replace the battery cover so that it clicks into place.
Make the settings
Start the indoor
for the weather
unit (the receiver)
station and check
and connect
that the sensors
the sensors
are working
8
Mount the sensors
in an appropriate
location