CO/Tech FT0203 Bedienungsanleitung Seite 10

1. Unscrew the retaining screw that holds the battery cover in place, and remove the cover.
2. Set the channel on which the sensor is to transmit by changing DIP switches 1−3
(see the table):
DIP switches*
1 2
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
* OFF = down, ON = up, DIP 4 = Down = Farenheit, Up = Centigrade
3. Insert 2 × AAA/LR03 batteries. The LED indicator will be illuminated for 3 seconds,
followed by continued flashing once every 60 seconds to indicate that data is
being transmitted from the unit.
4. The display shows the current temperature (C1)
and the relative humidity (C2). Check that
the correct channel number (C3) is displayed.
5. Replace the battery cover, ensuring that
the packing fits tightly around the battery
compartment, and tighten the retaining screw.
3 4
OFF °F / °C Channel 1
ON °F / °C Channel 2
OFF °F / °C Channel 3
ON °F / °C Channel 4
OFF °F / °C Channel 5
ON °F / °C Channel 6
OFF °F / °C Channel 7
ON °F / °C Channel 8
10
C1
C2
C3