Setup - EuroLite QuickDMX Bedienungsanleitung

5

SETUP

1
Connect the transmitter to the DMX controller and the receiver to the
QuickDMX USB input of the first DMX-controlled unit in the chain.
Connect a 120 Ω terminating plug to the DMX output of the last DMX
unit in the chain. Alternatively, provide each DMX-controlled unit with
its individual receiver to avoid cabling between the DMX units.
2
Set each transmitter and receiver into operation.
The status indicator shortly flashes red, green and blue. Afterwards, it
lights permanently depending on the selected transmission channel.
3
Set each transmitter and receiver to the same transmission channel.
For this purpose, shortly press the recessed button on the devices.
The selected transmission channel is indicated by the status indicator.
Channel
1
2
3
4
5
6
Thus, the wireless DMX network is set up and the receivers are paired
with the transmitter. The assignment of the receivers to the transmitter
remains valid even after the power supply has been disconnected.
4
As soon as the transmitter receives a DMX signal, the status indicator
switches to red. Shortly afterwards, the status indicators of the
receivers start flashing green to indicate that the DMX signal is being
received. The DMX-controlled units can now be controlled via radio.
www.eurolite.de
Color
Red
Green
Blue
Yellow
Turquoise
Purple
16