Herunterladen Inhalt Inhalt Diese Seite drucken

Saeco SM5479 Benutzerhandbuch Seite 21

Picobaristo
Vorschau ausblenden Andere Handbücher für SM5479:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 41
Problem
The coffee grounds
container is too full and
the message "Empty
grounds container" did
not display.
I cannot remove the
brew group.
 
I cannot insert the brew
group.
The coffee is watery.
 
 
 
The coffee is not hot
enough.
 
 
Cause
You removed the drip-tray
without emptying the grounds
container.
The brew group is not in the
correct position.
You have not removed the
coffee grounds container.
The brew group is not in the
correct position.
The machine is still in the
descaling procedure.
The grinder is set to a too
coarse setting.
The coffee exit duct is clogged.
The machine is performing its
self-adjustment procedure.
The brew group is dirty or
needs to be lubricated.
The cups you use are cold.
The temperature is set too low.
Check the menu settings.
You added milk.
Solution
When you remove the drip tray, also
empty the coffee grounds container
even if it contains only a few coffee
grounds. In this way the coffee grounds
counter will be reset to zero, re-starting
to correctly count the coffee grounds.
Reset the machine in the following way:
place back the drip tray and the coffee
grounds container. Then close the
service door and switch the machine off
and back on again. Try again to remove
the brew group.
Remove the coffee grounds container
before you remove the brew group.
Reset the machine in the following way:
place back the drip tray and the coffee
grounds container. Leave the brew
group out. Close the service door and
switch the machine on and off. Then put
the brew group in the correct position
and reinsert it into in the machine.
You cannot remove the brew group
when the descaling procedure is in
progress. First complete the descaling
procedure and then remove the brew
group.
Set the grinder to a finer (lower) setting.
Clean the coffee exit duct with the
spoon handle. Then switch the machine
off and on again.
Brew a few cups of coffee.
Clean and lubricate the brew group.
Preheat the cups by rinsing them with
hot water.
Set the temperature to 'high' in the
menu.
Whether the milk you add is warm or
cold, it always decreases the
temperature of the coffee to some
extent.
English
19

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Sm5471Sm5470Sm5460Sm5478Sm5473Sm5472

Inhaltsverzeichnis