Tuning In To A Preset Station; Time Setting - Azusa URZ2057 Bedienungsanleitung

TUNING INTO A PRESET STATION
1. When the radio is on (either MW or FM), press SET button (4)
or MEMORY+ (6) once, then the radio will be tuned to station
stored in the preset number next to the last loaded preset
number.
2. During the time when the LED is still showing the preset number,
choose the preset number by pressing MEMORY- button (5) to
step down the sequence or MEMORY+ button (6) to step up
the sequence.
3. After the preset number is chosen, it will be shown for 2 seconds,
then the LED will change back to show the radio frequency.
Important Note: Please do NOT hold (press continuously) the
SET button (4) in this stage. If this is done by mistake, the unit
will enter into the mode of presetting the station, with the preset
number flashing. In such case, do not press any button until the
LED stop flashing. Otherwise, your set memory may easily be
disturbed by your wrong operation procedure.

TIME SETTING

1. When the unit is first plugged into the AC mains, "0:00" will
appear and flash on the display.
2. Press HOUR button (8) for hour setting.
3. Press MINUTE button (7) for minute setting.
4. After setting to the correct time, either press SET button (4)
once, or just leave 5 seconds, then the display stop flashing,
and the clock will start run from the set time.
5. To adjust the current time, first switch off the radio. Press and
hold SET button (4) for 1 second until the display flashes, then
follow the same steps as point 2, 3 & 4 above to set the new
time.
DUAL ALARM FUNCTION
This product allows the user to set to dual alarm function. Each
alarm function can be set independently, either wake to radio, or
Owner's manual
EN
17