TFA 98.1030 Bedienungsanleitung Seite 8

TFA_No. 98.1030_Anleit_07_16
Radio-controlled alarm clock
with thermometer
• Unauthorised repairs, modifications or
changes to the product are prohibited.
Caution!
Risk of injury!
• Keep this instrument and the batteries out
of the reach of children.
• Batteries must not be thrown into a fire,
short-circuited, taken apart or recharged.
Risk of explosion!
• Batteries contain harmful acids. Low bat-
teries should be changed as soon as possi-
ble to prevent damage caused by leaking.
• Never use a combination of old and new
batteries together, nor batteries of differ-
ent types. Wear chemical-resistant protec-
tive gloves and safety glasses when han-
dling leaking batteries.
Important information
on product safety!
• Do not place the unit near extreme tem-
peratures, vibration or shock.
• Protect it from moisture.
5. Elements Fig. 1
Part A- LCD
A1: RC reception icon
A2: Radio controlled time
A3: Alarm icon
A4: Month and day display
A5: Temperature display
Part B- Buttons
B1: "SNOOZE/LIGHT" button
B2: "MODE/SET" button
B3: "+(12/24)" button
14
02.08.2016 15:48 Uhr
Radio-controlled alarm clock
with thermometer
B4: "-(C/F)" button
B5: "AL ON/OFF" button
Elements Fig. 2
Part C- Structure
C1: Battery compartment
6. Getting started
• Open the battery compartment and remove
the insulation strip. Close the battery com-
partment again. The unit is now ready to
use.
Radio-controlled time reception:
• After start-up the clock will scan the DCF
time signal ("
signal appears permanently when it is
received successfully. Important: Buttons will
not function while scanning for DCF unless
they are well received or stopped manually.
• The clock automatically scans the time signal
at 3.00 a.m. everyday to maintain accurate
timing. For failed reception, scanning stops
and repeats again at 4.00 a.m. 5.00 a.m. and
6.00 a.m.
• The clock manually scans the DCF time sig-
nal by holding "+(12/24)"- button and
"-(C/F)"- button for 3 seconds. For failed
reception, scanning stops and repeats again
the next 4 clock hours.
• Press "+(12/24)"- button and "-(C/F)"- but-
ton" again to stop scanning.
• In case the clock cannot detect the DCF-sig-
nal (for example due to disturbances, trans-
mitting distance, etc.), the time can be set
manually. The clock will then work as a nor-
mal quartz clock. (see "Manual setting of
clock and calendar").
Seite 8
" flashes on the LCD). The
15