Saeco Lavazza A MODO MIO Bedienungsanleitung Seite 12

E N
No liability is held for damage caused by:
• Incorrect use not in accordance with the intended purposes;
• Repairs not carried out by authorized service centres;
• Tampering with the power cord;
• Tampering with any parts of the machine;
• Use of non-original spare parts and accessories;
• Failure to descale;
• Storage at temperatures below 0°C (32°F);
• Use at temperatures below 10°C or above 40°C;
• Use at a relative humidity above 95%;
• Use of pods other than those indicated.
In these cases, the warranty is not valid.
STARTING THE MACHINE
Place the machine on a at and stable surface, away from water and
heat sources. Disconnect the power if connected. Lift the machine only
by using the appropriate lifting handle provided on the upper part. (See
MACHINE COMPONENTS
- Picture A). Damages to the machine re-
sulting from the failure to follow these instructions will not be covered
by the warranty.
L ift and remove the water tank cover, then the water tank itself.
1
Rinse the tank.
2
Fill the water tank up to the MAX
3
level indicated, using only fresh,
non-sparkling, drinking water.
Hot water or any other liquid may damage the tank and the appliance.
Do not operate the machine if water is not present: make sure there is
enough water in the tank.
Before turning the machine on, always make sure that the
EXTRA:
4
two switches are not pressed.
Connect the power cord. Press the main switch and bring it to the I
5
MACHINE COMPONENTS
position (see
EXTRA: power light turns on.
6
The dosed coff ee brew button and steam button are on,
PREMIUM:
while the coff ee manual brew button is blinking.
MACHINE SETTING
The use of a water fi lter improves the quality of the water and
increases the operational life of the machine by preventing lime-
scale build-up. Saeco recommends using the INTENZA BRITA FILTER
(optional accessory). To install the fi lter follow the instructions
provided with the accessory.
Upon the machine's fi rst start up and after a long period of
inactivity you need to rinse the water circuit as explained be-
low.
Place a container under the ste-
7
am / hot water wand and open
the knob slowly by turning it
counter-clockwise.
EXTRA:
8
PREMIUM:
EXTRA:
9
PREMIUM:
press the button again and dispense all water in the tank.
Press the coff ee brew button/switch again to end the process.
10
Close the knob.
11
Remove the container used and empty it out. Fill the water tank.
12
Place the container under the dispensing spout.
13
Pull the loading lever forwards
14
until it stops and without inser-
ting the pod. Repeat operations
described from step
Empty the container.
15
When the tank is empty, fi ll it
16
again.
- Picture B).
EXTRA:
machine is ready.
PREMIUM:
the machine is ready.
press the coff ee brew switch.
press the manual brew button.
EXTRA PREMIUM
Dispense all water in the tank.
wait for dispensing to stop automatically. If necessary,
to step
8
.
10
when the coff ee brew switch is steadily illuminated, the
when the two brew buttons are steadily illuminated,