Axis 215 PTZ Installationsanleitung Seite 7

AXIS 215 PTZ Installation Guide
Drop ceiling mounting
1. If possible, remove the ceiling tile in which the drop ceiling mount is to be fitted.
2. Use the supplied template to mark the position for the hole in the ceiling tile. Remove the
protective paper, fix to ceiling tile and cut around the template.
Note:
The combined weight of the camera, ceiling mount and cover is 1.26 kg (2.78 lb). Check
that the ceiling material is strong enough to support this weight. The thickness of the
ceiling should be 20-60mm (0.79"-2.36").
3. Tilt and insert the outer ceiling bracket through the hole, and then pull it into place. The
bracket should be positioned so that the 3 vertical tabs point downwards in the hole.
Outer ceiling bracket
4. Pull all of the required cables
(network, power, etc) down through
the hole, ready for connection.
5. Using the 4 supplied M4x10 screws,
mount the camera on the inner
ceiling bracket, as illustrated here.
Ceiling tile
Page 7
Hole diameter 168-175mm
(6.6-6.9")