–
This appliance is designed to function on AC current only. Before using it for the first time,
check that your mains supply voltage matches the one indicated on the appliance data
plate.
–
Any connection error will invalidate your warranty.
–
Always plug the appliance into an outlet with an earth connection. Do not use a socket
adapter or connect any other appliance into the same socket simultaneously, to avoid elec-
trical overloading and risk of fire.
–
Given the diverse standards in effect, if the appliance is used in a country other than that
in which it is purchased, have it checked by an approved service centre.
–
Remove all packaging materials, stickers, and accessories from the inside and outside of
the appliance.
–
The appliance must be placed and used on a flat, stable, heat-resistant work surface, away
from water splashes.
–
Do not place or use this appliance in high humidity environments.
–
Do not place or use the induction plate on steel or aluminium surfaces.
–
Maintain a gap of at least 10 cm (4 inches) on all sides of the appliance to ensure adequate
ventilation.
–
Never place or use the appliance close to a wall or below a wall cupboard.
–
Never place or use the appliance below or close to easily inflammable objects (e.g. cur-
tains, etc.).
–
Never place or use the appliance on or close to a cooking hob or other sources of heat.
–
Unwind the power cord fully before use.
–
•Do not use an extension lead. If you accept liability for doing so, only use an extension
lead which is in good condition, has a plug with an earth connection and matches the
power rating of the appliance.
–
Never leave the appliance unattended whilst connected to the power supply, even just for
a few moments, especially where children are present.
–
Do not let the power cord hang where children may reach it.
–
The power cord must never be close to or in contact with hot parts of the appliance, close
to sources of heat, or resting on sharp edges.
–
Take all necessary precautions to prevent anyone from tripping over an extension cord.
–
Switch off and disconnect the appliance from the power supply when not in use.
–
•Never disconnect the plug by pulling from the power cord.
–
Inspect the appliance and power cord for signs of wear or damage before connecting it to
the power supply.
–
Never move the appliance when it is hot.
–
Allow the appliance to cool down completely before you clean and store it.
–
Always keep the induction cooker clean to avoid dust from entering the fan motor and
MANUAL My Master GO.indd 13
ENGLISH
13
My Master Cooker
28/4/17 9:39