Setting Dip Switches; Location Of Dip Switches; Table For Setting Dip Switches - Citizen CBM1000 TYPE II Benutzerhandbuch

4. SETTING DIP SWITCHES

4.1 Location of DIP Switches

1 Turn off the power of the printer.
2 Open the printer cover.
3 Remove the paper roll and the DIP switch
cover.
4 After completing the setting, place the
cover to the original position.
CAUTION
• Do not make settings while the printer is
turned on.

4.2 Table for Setting DIP Switches

4.2.1 DIP switch 1
No. Function
1-1 Auto cutter
1-2 Unused
1-3 Paper width
1-4 Print columns*
1-5 CR mode
1-6 Input buffer
1-7
1-8
* It will be different according to the setting of paper width (DS1 – 3).
Print density
Print density
No.
1-7
1-8
Note: If print density is set to level 2 (Standard) or over, print speed may decrease.
ON
Available
-
58 mm
42 columns (80 mm)
30 columns (58 mm)
LF operation
72 bytes
Print density (See the tabel below.)
Level 1 Level 2
(Light) (Standard)
OFF
OFF
— 22 —
DIP switch cover
* DIP switch 3 is only for the
serial interface.
OFF
Not available
-
80 mm
48 columns (80 mm)
36 columns (58 mm)
Ignored
4K bytes
Level 3
(Slightly dark)
ON OFF
OFF ON
Factory presetting
ON
OFF
OFF
OFF
OFF
OFF
ON
OFF
Level 4
(Dark)
ON
ON