Electrolux IK2070SR Benutzerinformation Seite 67

Problem
The compressor does not
start immediately after
pressing the ActionFreeze,
or after changing the tem-
perature.
The compressor does not
start immediately after
pressing the Shopping, or
after changing the tempera-
ture.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The ActionFreeze function
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The ActionFreeze is
switched on.
The Shopping is switched
on.
The water drainage plug
is not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
or Shopping function is
switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
ENGLISH
Solution
Refer to "ActionFreeze func-
tion".
Refer to "Shopping function".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" .
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off ActionFreeze or
Shopping manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "Action-
Freezefunction" or "Shopping
function".
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
67