EUROM DryBest 30 Wi-fi Bedienungsanleitung Seite 24

24
Displays
Both displays (top and front) show the air humidity in the room.
If you enter the desired air humidity, this setting will be shown for a few seconds.
If you set an ON/OFF time using the timer, the display will show the set number of
hours for a few seconds.
If the air humidity is lower than 35%, the display will show 'LO' (low)
If the air humidity is higher than 95%, the display will show 'HI' (high)
Operation panel
1. [ Swing ] button
This button can be used to tilt the air outlet up and down for better air circulation in
the room.
2. [ Pump ] button (See installation)
With this button, a pump can be switched on to pump the water away. The water is
not captured in the water tank but can be drained to a drainage point so that the
water tank doesn't have to be emptied. The maximum pumping height is 3 metres.
Note: If you use continuous drainage, always check to ensure there are no leaks in
the hose connection before you leave the device unattended.
Note: switch the pump on ONLY if the drainage hose is installed or if the short,
pre-shaped hose that is supplied on the rear of the device is installed and goes
to the water tank. If you switch the pump on without a hose installed, the water
will flow out of the water outlet and onto the floor, where it could cause
damage.
3. [ TIMER } button
The timer button is used to set the times at which the device must come on and go
off. Press the Timer button and the light will go on. If you do this while the device is
off (but the plug is in the socket, but you've not pressed the ON/OFF button!), you
will set the start time. Press a couple of times on the Timer button to set the number
of hours after which you'd like the device to come on.
Press the Timer button on a working device and you will set the stop time. Press a
couple of times on the Timer button to set the number of hours after which you'd like
the device to go off.