Installation / Continuous discharge
When the dehumidifier is operated at very high humidity levels, the water tank will
require more frequent drainage. Sometimes it is therefore more efficient to provide a
continuous discharge.
There are two ways to connect continuous drainage to the device, i.e. you can drain
water to a lower water tank or water drainage device (without a pump) or drain it to a
higher water tank or drainage device (with a pump). The difference relates to where
you must attach the water hose to the device.
Water drainage downwards to lower water tank or drainage device (without
pump)
1. Pull out the water tank.
2. Connect an appropriate tube (included) with a clamp or draw strap on the drain
pipe, that becomes visible when you remove the water tank.
3. Put the water tank back to its position and lead the tube through the opening for
continuous drainage down into a drain or a big container. The short, pre-shaped
hose that is attached to the rear of the device, as standard, must be placed in the
same channel opening in the water tank. NB: this is important otherwise water
damage may occur!
Please note: in case, the water tank has not been positioned well, the water full
indicator keeps burning. The equipment does not work
4. Ensure the water will always drain away freely and the tube will remain in right
place. Note! In very cold weather conditions, precautions should be taken to
prevent the water tube from freezing.
Water drainage upwards to higher water tank or drainage device (with
pump)
1. Remove the short, pre-shaped hose that is fitted, as standard, to the rear of the
device (keep this in a safe place! )
2. Connect a suitable hose Ø 10 mm to the water drainage pipe, hose must
completely fit on the pipe otherwise water damage may occur, where you have
22