Functional Description; Intended Use; Product Features - Bosch GFF 22 A Professional Originalbetriebsanleitung

OBJ_BUCH-268-002.book Page 19 Wednesday, April 23, 2008 10:14 AM
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Always use the auxiliary handle supplied
with the machine. Loss of control can cause
personal injury.
The slip safety 9 must always be mounted.
Use only the cutting tools listed in these op-
erating instructions. Do not use cut-off discs
or circular saw blades.
Press the spindle lock button 15 only when
the machine is at a standstill.
Before putting into operation, check the
cutting disc for tight seating.

Functional Description

Read all safety warnings and all
instructions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

The machine is intended for cutting grooves for
biscuit dowel joints in chipboard, hard- and soft-
wood, plywood, fibreboard or artificial marble
(e. g. Corian®).
Bosch Power Tools

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Routing motor
2 Auxiliary handle
3 On/Off switch
4 Clamping lever of the angle stop
5 Height scale
6 Angle scale
7 Knob of the adjustable height stop
8 Centre mark of cut, horizontal
9 Slip safety
10 Adjustable height stop
11 Marks of cutting disc width
12 Centre mark of cut, vertical
13 Clamping lever of adjustable height stop
14 Direction-of-rotation arrow on housing
15 Spindle lock button
16 Attachment plate
17 Angle stop
18 Cutting depth adjustment knob
19 Lock nut for cutting depth adjustment
20 Knurled screw for cutting depth adjustment
21 Vacuum connection
22 Dust bag
23 Two-pin spanner
24 Clamping nut
25 Cutting disc
26 Direction-of-rotation arrow on the cutting
disc
27 Centring collar on mounting flange
28 Mounting flange
29 Cutter spindle
30 Spindle direction-of-rotation arrow
31 Base plate lock washer
32 Base plate clamping screw
33 Base plate
The accessories illustrated or described are not in-
cluded as standard delivery.
1 609 929 N81 | (23.4.08)
English | 19