Axis 216MFD Installationsanleitung Seite 11

AXIS 216FD/216FD-V/216MFD/216MFD-V Installation Guide
Adjust the image and focus
Open the Live View page in the web interface and make the following adjustments to the
camera:
1. Loosen the locking screw and
tilt adjustment screws.
2. Turn the lens to the desired
position.
3. Once satisfied, gently tighten
the locking screw and tilt
adjustment screws to secure
the camera's position.
4. Turn the image balance ring
to set the horizontal position.
5. Open the Focus Adjustment
page in the Web interface
under Basic Configuration >
Focus and follow the on-
screen instructions. Use the
image window to adjust the
focus and zoom.
6. To set the focus and zoom,
loosen the zoom and focus pullers anti-clockwise and rotate the rings.
Note:
Due to the dome's refraction, the image might appear slightly out of focus once
the dome has been placed. To compensate, focus on an object slightly closer than
the intended area.
7. Lock the focus and zoom pullers in position by rotating the screws clockwise.
The image can also be fine-tuned for low lighting conditions.
Go to Setup > Video & Image > Advanced and see the online help for more information.
Complete the installation
1. Rotate the black protective shield inside the dome casing to match the camera's position.
2. Clean the dome with a dry soft cloth to remove dust and finger prints and use a blower
to remove dust from the lens.
3. Mount the dome casing using the supplied tamper-proof screws and screw driver.
4. Now that the dome is in place, double-check that the camera is properly focused.
5. The installation is now complete.
Image
balance
ring
Tilt adjustment
screw
Locking screw
Page 11
Focus puller
Zoom puller
Tilt adjustment
screw