Using An Adapter - SoClean 2 Benutzerhandbuch

Figure 2. Connect the Injection Fitting
Injection
Injection
Hose A
Fitting
Injection
Hose B

2. Using an Adapter

If your PAP machine requires an adapter, see adapter
instructions for set-up and proceed to Step 5.
3. Connect the Injection Fitting
The Injection Fitting connects the SoClean to your PAP
machine. Once installed, you do not need to disconnect
the Injection Fitting to use your PAP. The SoClean is
intended to stay connected to your PAP continuously.
Note: Your PAP reservoir model may require additional
configuration procedures or an adapter. If you have
difficulty with the steps in this guide, visit:
SoClean.com for information on various models.
With humidifier:
1. Position the Injection Fitting onto the port of
your humidifier (where your PAP hose was
connected), allowing the smaller Injection Hose B
to enter into the reservoir (figure 2). The end of the
tubing should be positioned over the heat plate.
2. If necessary, carefully trim the Injection Hose B
in increments until it is the correct length, and
over the heat plate.
Note: The SoClean will disinfect your equipment with or
without water in the reservoir. The SoClean will purify
the water only if the end of Injection Hose is below the
water level.
For additional help to connect to your specific
machine, please visit our support pages at:
SoClean.com
ENG | 13