Cutting Tips; Maintenance; Description Of Symbols; Specifications - Blaupunkt MX6000 Bedienungsanleitung

CUTTING TIPS

Shaping The hedge should be trimmed to achieve a trapezoidal form, it should widen toward the bottom at both sides. This
improves the penetration of light to the lower extremities. A general guideline is approximately 10cm slant for each 1 metre of
hedge height. Cutting Sequence First cut both sides, starting at the bottom and working to the top: this prevents cuttings from
falling into the area where you are still to work.
Trimming the Top Where the branches have grown extremely long, cut back the hedge in several stages. The shorter cuttings
obtained are better suited for composting. General Information When older hedges are to be cut back a substantial amount, use
pruning shears or some other device to trim thicker branches (greater than 8mm diameter) to the desired length before starting
work with the hedge trimmer. To shape precisely, run a taught line between the extreme edges of the hedge and then trim along
the length of the line. Ensure that the blade does not come into contact with any object made of hard material that could damage
it, such as fencing wire or metallic plant supports. Our Environment we are care about the environment and consider what we may
do to protect it. If you share this concern you may already be aware of the suggestions below, if not please consider them as a small
step in protecting our future. Don't throw your clippings into a rubbish bin where it will be disposed of in land¬ll. You can dispose
of the clippings on your compost heap, alternating them with other garden material. Alternatively many communities provide a
public collection point where you can dispose of your garden waste in an environmentally friendly manner. Do not throw in general
waste. Dispose of hedge trimmer at a relevant recycling centre - this product contains a Lithium-ion battery.

MAINTENANCE

Keep the ventilation vents of the tool clean at all times, if possible, prevent foreign matter from entering the vents. If the enclosure
of the trimmer requires cleaning do not use solvents but a moist soft cloth. Never let any liquid get inside the tool: never immerse
any part of the tool into a liquid. The blade rail should be cleaned and treated with light machine oil or spray lubricant (such as
WD40,CRC 5.56 or RP7) after each use. When a job lasts for a longer period of time it is recommended that the blade rail also be
treated with spray lubricant at regular intervals during operation. Blade Cleaning to ensure many years of efficient and trouble-free
operation, blade cleaning should be performed if sap and debris have built-up, or if you live in an area where the soil is sandy.
Cleaning unusually heavy deposits may require removal of the blades. Note: Blaupunkt will not be responsible for any damage or
injuries caused by repair of the trimmer by an unauthorised person or by mishandling of the trimmer.

DESCRIPTION OF SYMBOLS

SPECIFICATIONS

Motor
Cutting length
Charge time
Run time
Hedge trimmer blade length
Blade length
Weight
V - Volts ~ -
AC - Alternating current
dc - Direct current
mA - Milliamperes
RPM - Revolutions or reciprocation per minute
Hz - Hertz
W - Watts
Ø - Diameter
no - No load speed
7.2V ,1500Ah
top blade: 118mm
upper blade: 91mm
3 - 5 hours
40 minutes (approx.)
150mm
top blade: 216mm
upper blade: 245mm
0.75kg