Blaupunkt MX6000 Bedienungsanleitung Seite 15

1. Turn the Hedge/Grass Trimmer upside down holding in one hand on a hard surface. Gently lift the tab of the blade cover (10)
and slide back until the cover can be removed (Fig. 5).
2. Insert the desired blade into the base of the motor housing (Fig. 6).
3. Align the 4 lugs for a secure fitment (Fig. 7). The gear shaft in the middle of the blade also has to be aligned.
4. Once the blade is in position, align the blade cover with the slots in the base of the motor housing (Fig. 8).
5. Push forward until it clicks into place (Fig. 9). The Hedge/Grass Trimmer is now ready for use.
To remove a blade
1. Turn the Hedge/Grass Trimmer upside down holding in one hand on a hard surface. Gently lift the tab of the blade cover (9)
and slide back until the blade cover (9) can be removed (Fig. 5).
2. Remove the blade gently by lifting the end tip of the blade o the Hedge/Grass Trimmer unit (Fig. 10).
3. Follow steps 2 - 6 to secure the blade.
Initial Operation 1. Push the safety lock-oswitch (4) forward, whilst holding the lock-oswitch forward depress the on/o(5) to start
operation. Once the trigger switch (5) is engaged you can release the safety lock-oswitch (4) (Fig. 11).
The safety lock-off switch reduces the risk of accidental starting. To stop the Hedge/grass Trimmer release the on/off trigger switch
(5) (Fig. 11).
Do not force the blades through dense growth. If the blades slow down, then reduce your pace. Should the blades jam, release the
trigger immediately. Do not use fingers to free up jammed blades. Jammed blades can release suddenly causing serious injury.
Never touch the blade rail while in operation and be aware of sharp edges even when the Hedge/Grass Trimmer is not in use. Always
ensure you are securely balanced with a free work area before switching on the Hedge/Grass Trimmer. Note: The yellow low charge
indicator LED (Fig. 2 (7)) will be illuminated when the battery is running low and requires charging.
Fig 5
Fig 8
Fig 6
Fig 9
Fig. 11
Fig 7
Fig 10