Blaupunkt MX6000 Bedienungsanleitung Seite 11

EN
INTRODUCTION
We hope you will enjoy using this tool for many years. Your Lithium Ion Hedge/Grass Trimmer has been designed for trimming
hedges, shrubs and grass around the garden and is intended for DIY use only.
!
Warning! When using mains-powered equipment, basic safety precautions, including the following, should always be
followed to reduce risk of ¬fire, electric shock, personal injury and material damage.
ELECTRICAL SAFETY
Read and understand the manual prior to operating this tool.
Save these instructions and other documents supplied with this tool for future reference.
The electric motor has been designed for 230V and 240V only. Always check that the power supply corresponds to the voltage on
the rating plate.
If the supply cord is damaged, it must be replaced by a qualified electrician or a power tool repairer in order to avoid a hazard. If
operating a power tool in a damp location is unavoidable use a residual current device (RCD) protected supply Use of an RCD
reduces the risk of electric shock.
Note: Double insulation does not take the place of normal safety precautions when operating this tool. The insulation system is for
added protection against injury resulting from a possible electrical insulation failure within the tool.
Using an Extension Lead
Always use an approved extension lead suitable for the power input of this tool. Before use, inspect the extension lead for signs of
damage, wear and ageing.
Replace the extension lead if damaged or defective.
When using an extension lead on a reel, always unwind the lead completely. Use of an extension lead not suitable for the power
input of the tool or which is damaged or defective may result in a risk of fire and electric shock.
SAFETY INSTRUCTIONS
Warning! A battery operated tool with individual batteries or a separate battery pack must be recharged only with the
!
specific charging unit for the battery. A charging unit that may be suitable for one type of battery may create a risk of re
when used with another battery type.
· Avoid accidental starting.
· When the tool is not in use keep it away from other metal objects.
Read the whole manual carefully and make sure you know how to switch the tool OFF, in an emergency, before operating the tool.
Save these instructions and other documents supplied with this machine for future reference.
GENERAL POWER TOOL SAFETY WARNINGS - PERSONAL SAFETY
1) Work area safety
a) Keep work area clean and well lit. Cluttered and dark areas invite accidents.
b) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control.
2) Electrical safety
a) Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs and matching outlets will reduce risk of electric shock
b) Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased
risk of electric shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil,
sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock.
e) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use
reduces the risk of electric shock.