Battery Charging - Blaupunkt MX6000 Bedienungsanleitung

BATTERY CHARGING

The length of service between each charge will depend on the type of work you are doing. The battery in this Hedge/Grass Trimmer
has been designed to provide maximum trouble free life. However, like all batteries, it will eventually wear out. To obtain the longest
possible battery life, we suggest the following: Store and charge your Hedge/Grass Trimmer in a cool area. Temperatures above or
below normal room temperature will shorten battery life. Never store the Hedge/Grass Trimmer with the battery in a discharged
condition. Recharge them immediately after they are discharged. All batteries gradually lose their charge. The higher the tempera-
ture the quicker they lose their charge. If you store your Hedge/Grass Trimmer for long periods of time without using it, recharge
the battery every 6 months. This practice will prolong battery life. The Hedge/Grass Trimmer has been shipped in a low charge
condition and should be fully charged prior to use. Plug the 230-240V charger adaptor (8) into an appropriate AC power outlet.
Connect the AC Adaptor charger plug (9) into the charging socket (6) of the hedge/grass trimmer and switch on the mains power
(Fig. 1). LED no.1 will illuminate red when charging. LEDs 2 & 3 will not be illuminated when charging. The battery will take approxi-
mately 5 hours to charge. This may take up to 7 hours due to the level of charge left in the battery and the ambient temperature.
NOTE: The state of charge indicator LED (7) will always be illuminated when the charger is plugged in and turned on. The charge
indicator indicates the charge of the Hedge/Grass Trimmer.
BATTERY CHARGING
Condition
Charging
Fully Charged
Low Charge
Initial Charge
Charge your battery for 5–7 hours then use it until it runs down and only slowly operates. Recharge for 5–7 hours again.
NOTE: The state of charge indicator LED (7) will illuminate red when the charger is plugged in and charging the Hedge/Grass
Trimmer. The state of charge indicator LED (7) will turn green on the middle LED light when the Hedge/Grass Trimmer is fully
charged.
Changing the blades of the Hedge/Grass Trimmer is equipped with two blades for all your gardening needs. The hedge trimmer
blade (2) is used to cut hedges and the grass shear blade (1) (Fig. 3) is used to cut grass and hedges where ¬finer detail is required
(Fig. 4).
Fig. 1
Colour of LED's
Red 1- Red, 2- Not illuminated, 3- Not illuminated
Green 1- Not illuminated, 2- Green, 3- Not illuminated
Yellow 1- Not illuminated, 2- Not illuminated, 3- Yellow
Fig .3
3
Fig. 2
LED's Illuminated
Fig 4
1
2