Docking Station - Klarstein 10028519 Anleitung

1 LED indicator
2 Infrared signal transmitting window
3 Charging electrode
4 DC socket
5 Code check button
Note: Before you use the docking station, code check is required; otherwise it will fail in self-charging. Steps of
code check:
A: Turn off the cleaner; Keep holding the code check button of the docking station; (Tip: the code check button
is inside the hole, you need to use auxiliary tools when hold the button). Turn on the cleaner;
B: After the cleaner toots 2 or 3 times , release the "OK" button, then the code check set is finished successfully.
C: If you fail to hear toot 2 or 3 times, during the code check, just repeat the above process.
Automatic Charging
1. Position the docking station on a hard, level surface against a wall. (Refer
to Figure 1). No obstacle or hollow areas 3m away from the docking station
in the front and 0.5m on the right and left.
3. The Robot cannot search the docking station for charging if the infrared
signal transmitting window of the docking station is covered. Connect the
output terminal of the adaptor with DC socket of the docking station. (Re-
fer to Figure 2).
5. Status of LED indicator: A: During charging to the main body, the LED light
will flash frequently at every 1 second. B: At standby status, the LED light
will light from bright to dark. Press the "ALL" button on the remote control
to turn off the LED light
Assembly & Disassembly of Dust Box:
A. Hold the machine bottom with your hand, press the button on the dust box (Refer to Figure 1)
B. Extract the dust box with the backward force.(Refer to Figure 2)
Figure 1

Docking Station

Figure 2
18