Accessories; Troubleshooting - Petsafe In-Ground Cat Fence Betriebsanleitung Und Trainingsanleitung

Accessories

To purchase additional accessories for your PetSafe In-Ground Cat Fence
website at www.petsafe.net to locate a retailer near you.
Component
Battery - two pack
Power Adapter for the Fence Transmitter
Gender changer for Power Adapter (UK use)
Replacement Collar
Additional Receiver Collar
Additional B oundary Wire
Additional Boundary Flags
Wire & Flag Accessory Kit
Fence Transmitter
Accessory Pack (Extra Contact Points, washers,
batteries, battery lid, and Waterproof Seal)
Receiver Collar is not beeping or
correcting.
The Receiver Collar is beeping, but
my cat is not responding to the Static
Correction.
The Receiver Collar has to be held on
top of the Boundary Wire to activate.
The Receiver Collar activates inside the
house.
I have an inconsistent signal.
Downloaded from www.Manualslib.com

Troubleshooting

• Check batteries to make sure they are installed properly.
• Check that both lights are lit on the Fence Transmitter. If not, perform
the "Short L oop Test."
• Make sure that Static Correction Level is at 2 or above.
• Test the Receiver Collar with the Test Light.
• If the Test Light fl ashes, check the fi t of the Receiver Collar.
• Trim your cat's fur where the Contact Points touch the neck and/or switch
to the longer Contact Points.
• Increase the Static Correction Level.
• Repeat training steps to reinforce training.
• Replace batteries.
• Adjust Boundary Width Control knob clockwise to increase the distance
from the Boundary Wire that the Receiver Collar activates. You can also
adjust the Boundary Control Switch to another setting.
• If using a Double Loop, make sure Boundary Wires are separated 1 to 1.5 m
(3 to 5 ft).
• If the Receiver Collar still has to be held on top of the Boundary Wire,
perform the "Short Loop Test."
• Turn the Boundary Width Control knob counterclockwise to decrease the
distance from the Boundary Wire that the Receiver Collar activates.
• Make sure the Boundary Wire is not running too close to the house. The
signal can transmit through the walls of your house.
• Make sure Boundary Wires are twisted from Boundary to the Fence
Transmitter.
• Make sure Fence Transmitter is at least 1 m (3 ft) from large metal objects
or appliances.
• Make sure all Boundary Wire turns are gradual.
• Make sure the Boundary Wire is not running parallel to and within 1.5 m
(5 ft) of electrical wires, neighboring containment systems, telephone wires,
television or antenna cables, or satellite dishes.
manuals search engine
™ , contact the Customer Care Centre or visit our
Part Number
RFA-35-11
300-026
300-263
200-1243
PCF-275-20
RFA-1
RFA-2
PRFA-500
RF-1010
RFA-39
www.petsafe.net 17