Filling The Reservoir - Medela SoftCup Gebrauchsanweisung

SoftCup™
Advanced Cup Feeder
The SoftCup Advanced Cup Feeder facilitates
feeding babies with sucking difficulties. It is an
excellent alternative to cup feeding.
Assembly
Lid
Pad
Silicone reservoir
Valve membrane
Valve plate
High rim on the upper side
Bottle
1. Press membrane onto valve plate (upper side),
so that the stud goes completely through the
central hole.
2. Pour required amount of milk into the bottle.
The milk should be at room temperature.
3. Put assembled valve across the mouth of the
bottle (make sure that the membrane and high
rim of valve plate are facing upwards).
4. Place the reservoir over the valve plate and
screw all the parts together with the lid.

Filling the Reservoir

Sqeeze
1. Hold the feeder upright and remove some air
from the reservoir by squeezing below the pads.
2. Keep squeezing and tip the feed er upside
down.
EN
Release