Assembly Of The Helmet Microphone - AKE 201 Bedienungsanleitung

wearing comfort. It is very important that thick padded helmets have their padding
perforated in this area.
Mark in your helmet the place where your earlap is located. Then you can proceed
as follows: Take a piece of insulating tape and put it where you think your earlap is
located. Then put on the helmet and prove with your finger if the marking is at the
exact place. Don't settle for less than the exact spot. This is the only way to get the
full advantage of all components!
Remove the protective paper on the back of the loudspeakers (self-adhesive) and
put them exactly below the markings in the helmet (connector pointing towards the
chosen side for the helmet connection) by putting a smooth pressure on the edge of
t he earpieces. The bonding surface has to be clean and even.
Now lay the cable and connect the yellow plug marked "R" and "L" with the
matching connection of the electronic box.
If you need to disconnect the plug again, please do not pull the cord to avoid
damage!

Assembly of the helmet microphone

The microphone is provided with a special
"close talking capsule" to efficiently
compensate the driving noise.
You can only take advantage of this
technique when installing the microphone
centrically in front of the mouth. In Helmets
that have a lot of space in front of the
mouth the microphone should be put on
an additional foam padding!
22
Mark in your helmet the selected place for the
microphone and clean the padding in the area
of the bonding surface, remove the protective
paper and press the microphone fi
the helmet. For some plastic material you need
a special adhesive.
Now lay the cable and connect to the blue
marked connection of the electronic box.
For open helmets there are high quality boom
microphones available, please refer to
accessories on page 29.
rmly onto