Easy Installation Of The Electronic Box; Assembly Of The Helmet Loudspeakers - AKE 201 Bedienungsanleitung

Important ! Before you start the installation, please read the following lines
carefully
Easy installation of electronic box
This Bluetooth device is working with low power
(class 2) and therefore represents no health
hazards regarding radiation when being
installed into the helmet. The ergonomic
housing in Stealth-design allows at helmets
with neck guard to invisibly and weatherproof
install the electronic box on the left side
between neck guard and helmet padding. An
additional fixing will not be necessary.
When using helmets without neck guard, the
Never install components in such a way that the protective effect of
If you are not sure, please ask your authorized

Assembly of the helmet loudspeakers

The assembly is according to the type of helmets used. First, check the padding in
the area of the ears. The closer the loudspeakers are to the ears the better is the
quality of the sound!
Most of the time the loudspeakers are placed under the foam padding for better
and mind safety advices!
e l e c t r o n i c
box could
be affixed to
the reverse side of the helmet with the enclosed
velcro fastener or with the in accessory
p
rotective bag
The electronic box could also be integrated in
the upholstering by a qualified service shop, if
recuested.
All external components can be removed for the
installation and have color coded plugs. Left
picture : Example of fixing with p
Attention
the helmet is limited!
AKE dealer or contact us directly.
( see on page 29 ) .
rotective bag
available
.
21