Operation - Klarstein Hot Spot Wave Handbuch

EN
20

OPERATION

1. Ensure that the Temperature Control Knob is at "Max" position. Also, make sure the
power switch is at "OFF" position.
2. Plug the power cord into a suitable electrical outlet.
3. Choose the function from the control knob.
Comfort mode: The heater will operate at the thermostat setting.
ECO mode: The heater will operate 4°C below the thermostat setting
without changing the thermostat position, and it will be cut-off the power
from 1°C to 3°C than the thermostat setting for energy saving.
Anti-Frost mode: It will keep the surrounding temperature above freezing
point to avoid the pipe breakage by ice.
5. Switch on the towel warmer and the power indicator light will be "ON" at the same
time.
6. Then adjust the temperature control knob to set the room temperature. According to
the personal needs, you can turn the temperature control knob in a clock-wise or
anti-clockwise direction to increase or decrease the room temperature.
7. When the room temperature reaches the pre-set temperature, the power will cut out.
The power will resume when the room temperature drops at least 3°C lower than
the pre-set temperature.
Function Control Knob