Commissioning And Operation - Klarstein 10034561 Handbuch

EN
12

COMMISSIONING AND OPERATION

The towel warmer is suitable for two 40"x70" (100x180 cm) towels. To achieve good
results, use 100% cotton towels or cotton blend towels.
1. Plug the power cord into the wall socket.
2. Remove the lid and place your dry towels inside.
3. Replace the lid.
4. Press and hold the on button until the timer led lights. The timer led will initially light
blue, indicating that the towel warmer is preheating (factory setting is 15 minutes).
5. Once the towel warmer has reached the optimum heating temperature, the led
will turn blue. To ensure that the towel is fully heated, leave the towel in the towel
warmer for a few minutes after the led indicator has turned red.
6. The towel warmer will maintain the optimum temperature until the time set in the
timer has elapsed (the countdown starts when the led indicator changes from blue
to red).
7. Press the off button to turn off the towel rail. The towel warmer will automatically
turn off when the timer time has elapsed.
Important notes
• The Hot Surface LED will illuminate to indicate that the inner surfaces of the towel
warmer are too warm to touch. When this indicator is lit, take special care when
moving the towel rail. Once the towel warmer has cooled down, the LED indicator
will turn off.
• Condensation on the cover is normal.
• Do not use the towel warmer to dry wet clothing. Only place dry towels, etc. inside
the towel rail.
• Only use the towel warmer to warm up textiles.