Starting up
After installation you need to program initial
settings. Turn the dial to the off position and
press the right-hand button for 5 seconds until
H600 code appears (maintenance menu reser-
ved for the installer).
Press OK.
The screen displays CF01.
5 sec.
CF01 — Correction of room temperature mea-
surement.
If there is a difference between the room tem-
perature and the temperature indicated by the
programmer, it is possible to correct it (from
-4°C to +4°C in steps of 0.1°C).
Press + or – to change the value, OK to confirm
it and go to the next menu.
49